Warmup Foil Heater Electric Underfloor Heating System

Warmup Foil WLFH-140W/140 1SQM Details

The WarmUp Electric Aluminium Foil when combined with Insulated Underlay and Dual Overlay can be used for safe heating under floors made of laminate, vinyl and carpets. The foil heater ensures consistent and even heat distribution and can also be used for wet area under floors without any additional earthing. When used together with Insulated Underlay, it significantly reduces heat-up times by at least 50%. May be used for all applications, primary or secondary adhering to Building Regulations. This super-thin, fully earthed flat aluminium foil will not raise floor levels and is super easy to install.

Foil layer acts a continuous earth layer within the floor construction whilst also diffusing the heat evenly
Installed directly under the floor finish; no self levelling required
Ideal for regular shaped rooms, where the 0.5m wide mats can be rolled out across the floor in parallel runs.
Suitable Floor Covering for Foil Heater: The Warmup Foil Heater is an electric underfloor heating system designed for laminate, engineered wood and other floating floor finishes.
BEAB Approved and CE marked meeting the highest safety standards for ultimate piece of mind
15 years of warranty and SafetyNet Installation guarantee from the manufacturer.
Refer the Installation manual PDF provided in the technical tab for installtion details
Floor drawing Pdf for slab and joist installation also provided in the technical tab
Key Benefits
Installed directly under the floor finish: No self-levelling required
No raise in floor levels: Super-thin, fully earthed flat aluminum foil will not raise floor levels
0Fit around objects:Wire based system, can be adapted to fit around objects, no need for complicated wiring
Suitable For:
Floor Type: Wood / Laminate, Vinyl, Carpet
Room Type: Large areas, Regular shape
Build Type: Renovation, New construction

Subfloors Type: Screed and Concrete Floors, Timber suspended and Batten floors
Technical Specification:
Operating Voltage: 220 - 240v: 50Hz
IP rating: IPX7
Width: 500mm
Mat thickness: 3mm
Cable thickness: 1.8mm
output rating: 140W/m2
Insulation: ETFE
Min installation temp: 5deg C
Connection: 3m Long "Cold tail" connection
Optional Products:
Optional sizes
Insulated underlay
Dual overlay
Thermostat

Please Note: MUST be used with Warmup Insulated Underlay. MUST be used with Warmup Dual Overlay when laying vinyl or carpet. ALWAYS check compatibility of flooring with electric underfloor heating