Cleargreen Ecocurve Shower Bath 1700 x 750mm

DAVID Asked :

The Cleargreen Ecocurve is shown to have taps in the centre of the bath. Can the tap be sited anywhere, or are there strengthened areas suitable for the mounting of the tap? Ideally, I would like a single tap hole at the narrow end or the middle. The plumber I am using to install the bath states the tap needs to be sited where the bath is the strongest.

Answered By QS Team

As this is a showering bath, the other edges are too slim for a tap to be mounted; there are strengthening rods under the whole bath rim, reducing the area even more. You can only put them on the ledge shown in the images.

Was this answer helpful?

Lorraine Asked :

How do I measure my bath to enable me to order the correct size bath panel for my existing bath? I don't know the bath's name; it doesn't have a name on it anywhere. I have looked. Kind regards Lorraine Cooper

Answered By QS Team

Thanks for your query, Lorraine. You can use this guide on how to measure bath panels. "http://www.qssupplies.co.uk/Upload/bath-panel-fitting-measuring-guide.pdf" Hope it Helps.

Was this answer helpful?

1 0

Denise Asked :

Hello, is there a 750 size end panel available with this bath? I can only see the 500 sizes listed. Thank you

Answered By QS Team

This bath is designed for corner installation, the 750mm side will go to the corner wall, and the optional panel will fit 500mm side, and Unfortunately, the end panels are one size only for Britton baths measuring at 496.

Was this answer helpful?

1 1

Dale Asked :

Is there a bath panel available for both ends? I can see a panel for the short end and the front - but not the long end? Can you suggest a suitable panel for the long end? Regards, Dale

Answered By QS Team

Cleargreen only has the bath panels facing the room and none that go round the back unfortunately as this bath is designed to sit in the corner of the bathroom.

Was this answer helpful?

2 2

Jason Asked :

I have just purchased a Mira mode shower and bath filler. The bath filler outlet measures 62mm in length, including the gasket. This needs to protrude from the waste hole on the Eco curve bath. Looking at the dimensions, this may be a tight fit with the front panel. However, it mounts on the angle and 70mm down so may clear. I would hope so. Can you confirm if it will? I would order bath, panel and screen but not sure until I am sure the filler will fit. I can send a pic/diagram if needed. Regards Jason

Answered By QS Team

If the rear of the filler, the piece that sits between the bath skin and the panel is 67mm, will not fit, you would need something nearer 40mm in depth not to foul the panel.

Was this answer helpful?

2 0

philippa Asked :

Can the screen on the clear green eco curve be fitted to the narrow end?

Answered By QS Team

Many thanks for your email. We wouldn’t recommend installing a bath screen at the narrow end. The narrow end has a slope and is not suitable to shower in that end, and the bath screen is also made for installation at the foot end.

Was this answer helpful?

2 0